Store      SERVICES      Instruments      Company      Reference      Home

SCHILKE MOUTHPIECE DESCRIPTIONS

The Schilke method of mouthpiece labeling has been designed to assist the student, teacher, amateur and professional in selecting a mouthpiece to meet the needs of the player. All mouthpieces come with standard rim shapes. cup volumes. and backbores unless shown otherwise on the mouthpieces.

Using this method it is possible for the player to know the characteristics of a mouthpieces in front of him.

SCHILKE MOUTHPIECE LABELING SYSTEMS

When a Schilke mouthpiece has a standard backbore, rim and cup, only the cup diameter (first number) is shown on the mouthpiece. In the example above only the #9 is necessary to identify the mouthpiece because the 'C' is the standard cup volume, '3' is the standard rim, and 'c' is the standard backbore. Whenever measurements differ from the standard sizes the alterations are shown on the mouthpiece.

CUP DIAMETER (First number in label)

Most trumpet and cornet mouthpieces have a cap diameter that falls between .600" and . 725". Nos. I to 25 in the Schilke system represent sections of .005" each between these two measurements. Cup diameters for mouthpieces other than trumpet and comet are relative to each other with the smallest numbers representing the smallest diameters.

CUP VOLUME (First letter in label)

In general the deep cup mouthpieces produce the darkest sounds. In reverse the shallow cup mouthpieces produce the brightest sounds and also aid in the production of the high register. The Schilke "C" cup is a compromise which offers both full tone and ease of production.

In switching from one instrument to another i.e., Bb trumpet to D trumpet, it is usually good to use a mouthpiece that is .025" shallower in the cup volume with all other dimensions remaining the same. The higher the instrument is, the shallower the cup should be.

A player who needs primarily a good range without sacrificing much tone can consider a hollow mouthpiece with a widened 2nd cup. The shallow 1st cup affords support in the top register and the widened 2nd cup allows a full tone.

RIM CONTOUR (Second number in label)

The #3 Schilke rim has the feel that most players prefer in a rim. It has flat enough contour to distribute the slight pressure needed to provide an air seal but is rounded slightly to offer increased flexibility. Generally a rounder rim will allow greater flexibility but sometimes tires the player sooner. A flat rim often feels the most comfortable but tends to hold the lips in a fixed position, thereby reducing flexibility.

BACKBORE (Last letter in label)

Schilke mouthpieces all come with standard backbores (letter C) which permit the maximum in tone and range. Other back- bores are available (Letters a, b, d, e) which might suit particular needs of players. The tighter backbores tend to make the sound more brilliant while the larger backbores tend to make the sound more mellow. Occasionally a change in backbores will cause an alteration in intonation which often can correct faulty intonation on an instrument.

THE FIT OF THE MOUTHPIECE

The shank of every brass mouthpiece when in the instrument should touch the end of the mouthpipe to insure an even taper from the backbore of the mouthpiece to the inside of the mouthpipe.

DIRT IN A MOUTHPIECE

Dirt inside the throat or backbore of a mouthpiece can greatly alter the intonation of the instrument on which it is used. Mouthpieces can only be kept clean with a mouthpiece brush used every week.

PHONE:1 (781) 646-5756

FAX: 1 (781) 646-2480

 COMPANY  |  SERVICES  |  STORE  |  INSTRUMENTS  |  REFERENCE   |  HOME

Visit our Retail Store and Repair Shop in Arlington, Massachusetts